MicroSquirt.com read only forum (Jan.15,2018)

Lance? any ideas?

ok will do, unfortunately i do not have a stim...as i bought the unit assembled...so if you can check out the setting and make sure im not doing that portion wrong...

my target is to have the +12v applied above 3500rpm...

thank you in advance

admins? you guys have any ideas?

anybody?

Ok to start im running the 2.35 code on a MSII v3.0

anyways.

1st: i wired per some instructions to get a VICS (variable intake control system or something along those lines...) running on my car...i wired the pin marked S12C to JS9 (+12C) and then jumpered (1A)JS0 to IAC1A which comes out at pin ...

ok now that the starting is easier...i have a spark knock...im assuming its a spark knock...now im gonna tell ya i have 10:1 compression and im running around 10 lbs...so with that in mind where in the spark map should i drop some timing? im assuming again here thats where i would do it to get this ...

Ok I have a MSII V3 board and im running 2.3XX
Vehicle is a 93 escort 1.8l turbo. 360cc injectors. (est 200hp and 175tq?)

anyways my prob is the car is very tough to get started. i would say usually it takes around 7 tries to get it to start...i have tried to adjust the ve table thinking its ...

OK so here is my new prob when it WAS running it was running good BUT it was almost impossible to start..once it did it ran good..so with that said it doesnt run anymore..i just found out that i burnt the coil driver out...the transistor has a spark right through the side to the heatsink...so i need ...

ok so i changed those three things...o2 is dead nuts now it seems, and the afr and ve are adjusted with the genrate table...now they are lower then what they were and the afr is showing like 11.2 or 11.3 either way i think thats better but its not 13...how would i get it higher?...which way do i go ...

ok the afr calibration i get now...thanks as far as the tps the stock one is a three wire and it reads on and off...so that would be much help i dont think...i bought a four wire and it wont fit on my tb (didnt know that when i bought it..). the gentleman i bought the MS from said i could use a ...